The GardnClean Chlorine Dioxide (ClO2) Fast Release is a true dry gas fumigation for deeply deodorizing any space or environment

This includes hard to reach areas such as microscopic openings on non-sealed materials, HVAC ducting, electrical components, and much more. Due to the very small size of the chlorine dioxide molecule, it can easily penetrate into all of these spaces to eradicate the source of VOCS (Volatile organic compounds), odors, and other compounds from deep within. Great to use in transportation, bathrooms, kitchens, offices, common areas and dwellings.

Although GardnClean Fast Release can be used on its own, we recommend that all surfaces should be thoroughly cleaned and disinfected with GardnClean GC Liquid before performing a Fast Release Gas Treatment.

Just add water to active

Fast-acting 3-Dimensional gas treatment

Higher part per million for your deep cleaning needs

Minimum treatment time of four hours

The sachet is landfill friendly

Discard excess liquid down any drain

PPE Required

Complete Environmental Deodorization

Directions For Use:

1. Turn off lights and close blinds as Chlorine Dioxide (CIO2) is photoreactive.

2. If treating individual rooms, seal off room to prevent the gas from exiting the room.

3. If possible, use GardnClean GC liquid at 100 ppm to spray down all surfaces in the room before using GardnClean Fast Release. (The evaporation of the GC Clean Liquid acts as an additional fumigant, resulting in an entourage effect.)

4. Place the GardnClean Fast Release in the center of the room, as high up as possible. The ClO2 gas will disperse throughout the entire room. ClO2 is heavier than air, so do not place under tables or any obstructions. We recommend using fans to help keep the ClO2 dispersed evenly throughout the space. If treating all areas on a shared HVAC system, you can place the Fast Release by the return and allow the HVAC system to disperse the gas into the environment.

5. Remove foil pouch from the jar, remove GardnClean Fast Release sachet from the foil pouch without tearing the sachet inside.

6. Place GardnClean Fast Release sachet in the provided jar and fill with approx. 175 ml of water (to the fill line).

7. Leave the room immediately and stay out room for a minimum of 4 hours.

8. Ventilate the room for at least one hour before returning without PPE.

9. Upon re-entry dispose of remaining liquid in the container down any drain and discard sachet into any trash receptacle. *Although GardnClean Fast Release can be used on its own, we recommend that all surfaces should be thoroughly cleaned and disinfected with GardnClean GC Liquid before performing a Fast Release Gas Treatment.*

For full instructions, see our Directions for Use on the label, or consult the GardnClean Institutional SOP.